Hot Beverage Maker User Manual

HOT DRINK SETUP/PROGRAMMING GUIDE
November, 2002 Page - 8 6700001
HYDROLIFE BRAND
INSTALLATION:
1. Place the filter inside the canister. Be sure the o-ring is seated in the canister just
below the threads.
2. Screw the canister and filter assembly onto the filter head until it comes to a stop.
3. Open the water valve on the inlet line by rotating the handle to the vertical position
as shown.
REMOVAL
1. Close the valve on the inlet line by rotating the handle into the horizontal position
as shown.
2. Relieve water pressure by performing two or three water throws (see the
programming section).
3. Unscrew the filter and canister assembly from the filter head. Remove the filter
from the canister.
FILTER
CANISTER
O-RING
OPEN
POSITION
HYDROLIFE
FILTER HEAD
INSTALL
REMOV
E
OPEN
POSITION
CLOSED
POSITION
VALVE