Hot Beverage Maker User Manual

HOT DRINK SETUP/PROGRAMMING GUIDE
November, 2002 Page - 94 6700001
VIEW AMOUNT IN VALIDATOR (NOT SHOWN IF ZERO)
1. Press , then press until the display shows
DBV XX.XX.
"XX.XX" is the dollar amount in the bill stacker.
2. Press to show the quantities of bills in the stacker. For
example, the display shows $0120, meaning that there are 20 dol-
lar bills in the bill stacker. Press again to show the quantities
of other bills, such as $5s, $10s, or $20s.
3. CONTINUE.
VIEW DIAGNOSTIC MESSAGES
Press . The display shows any of the following diagnostic
messages, depending upon any fault(s) present:
NO ERRORS None of the following errors are detected:
KEYPAD XY Key(s) x, y stuck.
ROM ERROR Key(s) x, y stuck.
RAM ERROR RAM is not initialized or is not compatible with
the currently loaded software. If this message
appears, initialize your RAM by performing the
following procedure:
NOTE:
Initializing RAM will erase all your data and drink settings.
Be sure you have written this information down before continuing.
Press and hold until two beeps are heard, and the display
shows FINISHED.