Manualshelf

Window User Manual

ManualsBrandsCrane Merchandising Systems ManualsOther480
919293949596979899100
Programming Procedures Refreshment Center Operators’ Guide
4800006 92 December 2004
ROM checksum failure. The unit will disable itself until the error is
corrected. Replace the validator.
One of the sensors in the bill validator has failed. The unit will disable
itself until the error is corrected. Check for bill stuck in the
acceptance path. If no bill is present, replace the validator. Cycle
machine power OFF and then ON.
The stacker is open or removed. The unit will disable itself until the
error is corrected. Install the stacker correctly.
The stacker is full of bills. Remove bills from the stacker.
Error exists on tray A, B, C, etc. Motor may be jammed, not home, or
a couple error exists.
(The * is flashing.) Jammed door.
(The 2 is flashing.) Door seen as open and closed.
(The 3 position is flashing.) Could not find the closed position.
(The 2 position is flashing.) Could not find the open position.
(The 1 position is flashing.) The loading door is open.
(The 3 position is flashing.) Not in the shut position.
º
Refrigerated products went out of service on date-time MM/DD/YY
HR.MN because of a health MM/DD/YY HR.MN control error. The
maximum temperature reached after this time was XXºF.
Refrigerated products went out of service on health control. Only
trays A and B are available.
Refrigerated products went out of service on health control. Only
trays A, B, and C are available.
One of the motor sensor lines is idling in an incorrect state. This error
could indicate a bad interface board or a bad or pinched harness.
Disconnect the harness and see if the error disappears. If so, the
harness is to blame. If not, suspect the interface board.
- indicates an error in the snack matrix (section)
- indicates an error in the even home line
- indicates an error in the odd home line
- indicates an error in both odd and even home lines
- indicates an error in the can unit (if available)
Key(s) x, y stuck.
This error is generated if the freevend key switch is on, but the
machine is not configured with free w/ key.
ERROR MESSAGES (CONTINUED)