Window User Manual

Refreshment Center Operators’ Guide Programming Procedures
December 2004 91 4800006
VIEW DIAGNOSTIC MESSAGES
1. Press . the display shows any of the following diagnostic messages, depending
upon any fault(s) present:
ERROR MESSAGES
None of the following errors are detected:
This appears if the SureVend™ anti-jackpot timer is active, showing
the time remaining on the timer. This timer is cleared upon closure of
the main service door.
This shows the total number of times the SureVend™ anti-jackpot
feature occurred plus the date and time of the last occurrence. Press
to reset this count.
Incomplete card reader communications. Check cables or replace
unit.
Incomplete card reader communications - check cables. The card
reader is not operational.
Card reader is indicating it has a problem.
Card reader has an error and indicates code XX. The code is defined
by the card reader manufacturer. To correct, contact card reader
manufacturer. The unit is still operational.
Card reader is indicating it has failed. Replace unit.
Card reader has failed and indicates code XX. The code is defined
by the card reader manufacturer. To correct, contact card reader
manufacturer.
Card reader has failed because card is jammed in the unit. Remove
the jammed card.
Card reader requires service. The unit is still operational.
Price error detected and changed to maximum - check prices.
A PRODUCT CONFIG value was out of bounds and set to nominal -
check all PRODUCT CONFIGs.
The vending machine is telling the bill validator not to accept any bills.
Check the enabled channels of the bill validator.
Incomplete bill validator communications -- check harness.
A bill is jammed in the acceptance path. The unit will disable itself
until the error is corrected. Remove bill stuck in the acceptance path.
Cycle machine power OFF and then ON.
One of the motors has failed. The unit will disable itself until the error
is corrected. Check for bill stuck in the acceptance path. If no bill is
present, replace the validator. Cycle machine power OFF and then
ON.