Window User Manual

Load the Merchandiser Refreshment Center Operators’ Guide
4800006 36 December 2004
Configure the Merchandiser for Vending "Top Shelf"
National Vendors recommends that this product be vended from a candy tray.
1. Move the tray so the package can be loaded standing on its left or right edge.
( See "Move a Tray Up or Down" on page 30).
2. The following steps must be completed for three adjacent positions on the tray:
NOTE
The left-most position in the group of three must be an even numbered position.
NOTE
If the motor harness disconnected in step 5 does not reach, use the motor skip harness, (P/
N 1599024), available from the National Vendors Parts Department (800-621-7278).
3. Couple the left motor to the right motor. (See "Couple/Uncouple Tray Motors" on
page 67).
4. Load the "Top Shelf" products as shown.
1. REMOVE COLUMN
DIVIDERS
2. REMOVE
SPIRALS
7. INSTALL AN 11-COUNT LEFT HAND
SPIRAL IN THIS POSITION
INSTALL AN 11-COUNT RIGHT-HAND
SPIRAL IN THIS POSITION
8.
157P0040
4.
DISCONNECT THIS
MOTOR CONNECTOR
3.
LEAVE THIS MOTOR
CONNECTOR ALONE
5.
MOVE CONNECTOR
FROM THIS MOTOR
6.
TO THIS MOTOR
TOP SHELF
PRODUCT