Window User Manual

Refreshment Center Operators’ Guide Load the Merchandiser
December 2004 35 4800006
Product Pusher Usage
The product pusher will give the top of a product an
extra tilt to help it fall into the delivery pan.
Use a product pusher in the following cases:
• The spiral has a capacity of 15, 13, or 11.
• The package is non-rigid like bagged
peanuts
The product pusher can also be used with other
spiral and types of products.
A bag of product pushers has been shipped with the
merchandiser. Additional product pushers are
available from the National Vendors' parts department (800-621-7278). To use a product
pusher, snap it on the spiral as shown. You can adjust the product pusher by moving it
around on the spiral to achieve the best vending results.
Configure the
Merchandiser to vend
“Lunch Buckets”
Because of the weight and shape of the
package, National Vendors
recommends that this product be
vended only from the bottom tray.
To vend this product, two adjacent
positions must be coupled together.
The left spiral coupler should be
installed one position counterclockwise
from the vertical position.
The right spiral coupler should be installed one position
clockwise from the vertical position.
Replace the current spirals with six-count spirals.
These are available from the National Vendors parts
department. (See "Remove and Install Spirals" on
page 25). A pad can be installed in the bottom of the
delivery pan to quiet and cushion product delivery. This
part is available from the National Vendors parts
department. Load "Lunch Bucket" products as shown
at left.
PRODUC
T
PUSHER
LEFT SPIRAL
COUPLER
RIGHT SPIRAL
COUPLER
AS VIEWED FROM FRONT OF TRAY
ONE POSITION
C
OUNTERCLOCKWISE
FROM VERTICAL
ONE POSITION
CLOCKWISE
FROM VERTICA
L
FOOD SELECTIONS
LOADED IN SPIRALS
157P0039