Manual

HIGH HUMIDITY ROOMS
Acclimate panels in the operating humidity conditions. Carefully follow the guidelines in this installation guide for expansion/contraction
spacing and sealing. (see Expansion Joint Chart, pg 5). Failure to seal moisture entry points with silicone sealant can cause swelling
of the substrate resulting in warping, curling, delamination or bond line separation. Use an adhesive that is recommended for high
humidity conditions. A vapor barrier (e.g. 6 mil poly sheet) may be required. *Follow the architect or owner’s specifi cations or check your
local building codes for specifi c requirements.
LOW TEMPERATURE CONDITIONS
Acclimate panels in the operating temperature conditions. Carefully follow the guidelines in this installation guide for expansion/
contraction spacing and sealing (see Expansion Joint Chart, pg 6). Use an adhesive that is recommended for low temperature
conditions.
A vapor barrier (e.g., 6 mil poly sheet) may be required. Follow the architect or owner’s specifi cations or check your local
building codes for specifi c requirements.
FOAM INSULATION
An approved thermal barrier system (e.g., gypsum board) must be used between the FRP
panels and any foam insulation
(Figure 2). Check your local building codes for specifi c
requirements.
NEAR HEAT SOURCE
FRP panels will discolor when installed behind or near a heat source
which radiates
temperatures exceeding 130°F (55°C), such as cookers, ovens, and deep fryers. Stainless
steel is recommended for these types of areas.
Choose an Adhesive
The following information provides assistance on selecting the appropriate adhesive for installation:
CRANE ADVANCED POLYMER ADHESIVE
Porous and most non-porous substrates, Interior and exterior applications, Fiberglass faced, mold resistant and fi recode core drywall,
drywall, steel, foamboard, vinyl, PVC, FRP,ceramic tile, laminate, sealed and unsealed concrete
CRANE FAST GRAB ADHESIVE
Porous substrates, Interior drywall applications, Non-treated plywood
ADHESIVE RECOMMENDATIONS FOR VARIOUS SUBSTRATES
Refer to form #6846 for additional Crane Adhesive installation information.
FRP to:
Advanced
Polymer
Fast Grab
Standard unpainted drywall YES YES
Standard unpainted plywood YES YES
Treated plywood YES NO
Fire rated plywood YES NO
Cement board YES NO
Fiberglass faced, mold resistant
and fi recode core drywall
YES NO
DensGlass YES NO
FRP YES NO
Traditional Greenboard YES NO
Ceramic tile YES NO
FRP to:
Advanced
Polymer
Fast Grab
Stainless steel YES NO
Metal YES NO
Aluminum YES NO
Galvanized metal YES NO
Cement block
(above grade or inside wall)
YES NO
Cement block
(below grade or outside wall)
YES NO
Painted walls
(if paint is well anchored)
YES NO
Polystyrene foam YES NO
Polyurethane foam YES NO
Foil-faced insulation YES NO
Figure 2
5