Manual

General Information

Safety Information

WHEN CUTTING OR DRILLING, ALWAYS WEAR PROTECTIVE GLASSES OR GOGGLES AND A FACE MASK WHICH COVERS

THE FACE AND MOUTH. Itching due to glass ﬁ bers may be avoided by the use of barrier creams on exposed skin areas. Hearing

protection is also recommended.

Supplies and Equipment

Supplies will vary depending on wall substrate, adhesive choice and seam treatment selection.

STANDARD FRP TOOLS NEEDED

• Crane Composites Laminate Roller (Part # R50ROLLER)

• Crane Composites V-notched Trowel 3/16′′ x 1/4′′ x 5/16′′ (Part # R50TROWEL)

• Circular saw with ﬁ ne tooth carbide tipped saw blade

• Swivel-head 18 gauge shears

• Drywall Roto-Zip®

• Jig-Saw

• Flat edge ﬁ nishing tool (putty knife or equivalent)

MATERIALS NEEDED

• Crane Composites Standard FRP or Innovative Finishes Panels

• Adhesive - Crane Advanced Polymer Adhesive (R53829) or Crane Fast Grab Adhesive (R53828)

Refer to page 5 for assistance in selecting the appropriate adhesive

• Soap and water for clean-up (Latex or Polymer adhesives)

• Saw horses

• Plywood larger than panels

• Dry, lint free rags

• Sandpaper or Paper Tiger® Wallpaper Removal Tool for roughing up wall

• Tape measure

• Utility knife

• Six-penny ﬁ nishing nails

• Carbide tipped laminate cutter

• IMPORTANT NOTE: If installation room has high humidity (65% or higher) then a portable low-cost dehumidiﬁ er unit is suggested.

SEAM TREATMENT

• Moldings

• Color Coordinating Caulk

• Seam Sealant (cleanroom only)

• Cleanroom Wall System Seam Sealant - 7555 Urethane Sealant (R53827)

• Applicator - Pneumatic Dual Chamber Applicator Gun (R50CAULKGUN)

• 400ml Static Mixing Tips - 3/8′′ x 11′′ x 24 EL

• Finishing Kit - Inline Seam and Radial Seam Finishers for seam smoothing (R50SEAM-KIT)

• Panel Tape - 1′′ by 144 yds (R53522)

• Solvent for clean-up (IPA, acetone)

• Protective gloves needed when using seam sealant

Storage

Panels should be stored indoors on a solid, ﬂ at, dry surface other than the ﬂ oor. Do not stack on concrete ﬂ oor or any other surface that

emits moisture. Lay panels ﬂ at with proper support on the ends of panels. Do not stand panels on edge. All FRP panels must be stored

inside. Optimum storage conditions are 60° to 75° (16°C to 24°C) and 35% to 55% relative humidity

(Figure 1)

Figure 1