User Manual



Hardware Setup: Using C.A.S.T.



This hardware setup diagram will get Camden EC2 connected within a C.A.S.T. enabled system

alongside a 500R8/500ADAT and N22/N22H breakout box:



1. Connect mains power into the external PSU supplied in Camden EC2’s packaging and

connect the Power Connector into Camden EC2’s Power Inlet [11].



2. Connect Camden EC2’s C.A.S.T. Output [9] to a C.A.S.T. Input on 500R8/500ADAT using a

shielded Cat 5e, Cat 6, or Cat 7 cable.



3. Connect N22 or N22H’s C.A.S.T. Output to Camden EC2’s C.A.S.T. Input [1] using a

shielded Cat 5e, Cat 6, or Cat 7 cable.



4. Power On Camden EC2, followed by 500R8/500ADAT and other downstream

equipment.



5. On Camden EC2, set the rear panel source switches for Preamp channels [2] into its

down position to enable the C.A.S.T. Input connection to be fed into it’s preamp



Now, connect Mic/Line sources to either of N22’s inputs, apply Gain and your desired Mojo

setting on Camden EC2, and now the preamp signal will be sent out from Camden EC2 and

directly into 500R8’s slots ready for further processing and recording.



At the same time, the Aux Mix created on 500R8/500ADAT is sent down C.A.S.T., into Camden

EC2 and into the connected N22/N22H. The Aux mix can also be monitored using Camden

EC2’s Aux 1/Aux 2 Headphone outputs as well as the connected N22/N22H.

 