Installation Guide

(Concrete wall) (wood wall)
Main Body Valve Installation
Step1
1.Make marks according to the size of the main body valve, and then drill anchors into
the wall (concrete wall).
2.Lock the main body to wood directly with screws (wood wall).
3.When installing the main body, please mark the UP side up and do not install it
upside down.
▲ Please note that the level meter should be parallel to the wall; otherwise, the deck
plate cannot be installed.
1.Please install the deck plate, water diverters, and water diverter rods step by step.
2.Install the handle with the screw and handle cap.
Precautions for Handwheel Installation
1.The line can't be misplaced; it should be kept
in line. Otherwise, the water temperature of
100°F or 38°C will not be correct.
line
2. Please ensure that the plastic locating ring (A)
and handwheel locating pin (B) are kept in the
same line with 100°F or 38°C. Otherwise, the
water temperature will be incorrect.
Step2
Do not remove the white wear ring;
otherwise,the handwheel will be
damaged.
Water flow control:clockwise Turn-down
and stop ,anti-clockwiseTurn-up to max
5
anchors