Installation Guide

Brightness is
adjustable
Speed is adjustable
The touch remote has 9 touch keys, each of which functions as follows:
Controller connections shown:
2. Power supply management:
The remote will enter standby mode (untouchable state) if pressed for more than 20 seconds. If this
occurs, please slightly shake it once and the remote will return to normal working state (touchable state).
3.Indicator light instruction:
3.1.When the PWR indicator light is bright, the remote is either idle or sending a signal; when the PWR
light is off, it will enter standby mode.
3.2.When RF is bright,it means the remote is sending signal; off means there is no signal sending.
Remarks:
1.This product should be commissioned and installed by qualified personnel.
2.This product cannot be waterproof; it needs to be protected from sun and rain. If installed
outdoors, please use a waterproof box.
3.Good heat dissipation conditions will extend the life of the LED controller. Please install the
product in a well-ventilated environment
4.Please do not install or use such products in lightning, thunder, strong magnetic or high
voltage applications.
5.Please check whether the output voltage of the LED power supply used meets the product
voltage range requirements.
6.The diameter of the wire used must be sufficient to support the connected LED luminaire,
and ensure that the wiring is secure to avoid the wire overheating or poor contact triggering
an accident.
7.Before power-on debugging, ensure that all wiring is correct to avoid damage to the
luminaire due to wiring errors.
LED Touch Remote lnstruction
① Turn ON/OFF
⑤ Mode Switch
② Color Touch Ring
③/⑥ Color Temperature adjusting
④/⑧ Dynamic Speed adjusting
⑦/⑨ Dynamic Brightness adjusting
Mode:
FUNCTION REMOTE
Brightness is adjustables.
speed is unadjustable.
Static red
Static green
Static blue
R G B Jumping
Static blue-green
Static yellow
Static white
Static purple
R G B Gradual
7-Colors Gradual
7-Colors Jumping
NO.
1
2
3
4
5
6
9
7
10
11
8
12