Installation Guide

Installation The Hand Show Holder
Step1.Remove the male connector from the top of the shower holder
(do not damage the gasket, otherwise it will leak).
Step2.Screw the thread into the water pipe inside the wall
Step3.Screw the main body into the thread.
Step4.Rotate and fix the body with the special-shaped wrench
Step5.Connect hand shower and the hose.
Step 1 Step 3
Step 4 Step 5
Step 2
G1/2
NPT1/2
USA:1/2"-14 NPT
20mm
6/8"
24mm
15/16"
Precautions
!
Body Jets Installation
Step 1: Ensure that the threaded pipe and the raw material tape are of matching sizes to
avoid misalignment when screwing into the wall.
Step 2: When disassembling the product's threaded pipe, handle with care to avoid
damaging the threads or other components.
Step 3: Wrap the NPT1/2 threaded pipe with an appropriate amount of raw material tape to
ensure a good seal at the threaded connection, but avoid excessive force.
Step 4: When screwing in the massage nozzle, ensure a secure connection, but avoid using
excessive force to prevent affecting the nozzle or the wall.
Step 5: After confirming completion of all installation steps, check for any water leakage or
looseness to ensure a complete and securely stable installation.
7
Step2Step1Step3
Step4
Step5
Female thread
elbow
Water outlet
connector