Datasheet

Electronic Components
Crameda Intersys AG Tel. +41-71-370 01 15 MS-U-E-060915.doc
Kirchstrasse 22 Fax +41-71-370 01 16 Page : 6
CH-9113 Degersheim ยท Schweiz http://www.crameda.com
Terminals
Multiswitches are equipped with pin connections as standard.
Alternatives are: solder pins or wire wrap pins.
Limit stops
Upon request, all Multiswitches, except series D and Z, can be
provided with limit stops.
The stop pins (model series H, L, M, S, U, V, W) can be set
from outside by the user.
The stops (series A, B, G, P, Q, R and, H and M 16 positions)
are set during assembly and cannot be changed later.
Coupled switches
Blind slave switches have the same technical specification as
standard switches, but have no thumbwheel and are closed at
the front. Each blind slave switch is equipped with a coupling
element. They are coupled to a Multiswitch of identical size on
the left or right hand side.
Please note: Blind slave switches are available in series A, B,
G, H, L, M, P and V.
Dummy switches
Dummy switches appearance is identical to the standard
switches. However, the dummy switch has no contacts or
printed circuits inside. It can be useful in satisfying aesthetic
layout requirements.
Dummy switches are not available for series D or Z.
Blank spacing module
A blank spacing module has the same dimensions as the
corresponding Multiswitch.
It can be placed in any position within the switch assembly,
allowing desired subdivisions.
Blank spacing modules are not available for series R.
Distance plate
A distance plate is half as wide as a corresponding
Multiswitch. It can be placed in any position within the block
assembly, allowing desired subdivisions.
Distance plates are available in series D, H, and P.