Datasheet

Crameda Intersys AG CC-DS-E-0011
Pumpwerkstrasse 23 Seite : 2
CH-8105 Regensdorf · Schweiz http://www.crameda.com
Mounting instructions
Assembly
The individual display modules are lined up in blocks. Each
block is completed with end brackets. The block is secured
with threaded rods.
The assembly procedure is completed after the block is
inserted through the cut-out in the front panel.
The snap springs provide reliable fastening power. In series
100 and 300, the individual modules are assembled into
blocks simply by pressing them together (push-fit principle).
Threaded rods can be used in both these series to fulfil
extreme requirements.
Additional assembly of division plates or
dummy housings
A display block can be subdivided into groups with dummy
housings. If selector switches are to be integrated in a display
block, the division plates will provide a neat transition between
display and switch modules. Switches can be mounted on
either side of the display modules. In series 100 and 300, the
division plates are one-piece elements. In the other series,
they are composed of a division plate of the display series
and of a division plate of the corresponding Multiswitch
series. Centering sleeves simplify assembly procedures.
Mounting material
In series 500 and 800, modules are assembled with two M2
threaded rods and two M2 slotted nuts. For increased
strength, series 100 / 300 can also be assembled with
threaded rods and slotted nuts of size M2.
Connections
All plug connectors are hard gold-plated. A matching
connector program is available.