Operator`s manual

ELECTRICALSAFETY

I_WARNING: Do not permit fingers to touch the terminals of plug I

when installing or removing the plug from the outlet,

1. Double insulated tools are equipped with a

polarized plug (one blade is wider than the

other). This plug will fit in a polarized outlet

only one way. If the plug does not fit fully in the

outlet, reverse the plug. If it still does not fit, contact

a qualified electrician to install a polarized outlet.

Do not change or alter the plug in any way.

2. Double insulation [] eliminates the need for the

three-wire grounded power cord and grounded

power supply system. Applicable only to Class II

(double-insulated) tools.This trimmer is a double

insulated toor.

Cover of @

Grounded

Outlet Box-

A CAUTION: This trimmer has a 12-in. Pigtail Power Cord that

must be plugged into a proper extension cord (see page 7).

/k WARNING: Double insulation DOES NOT take the place of

normal safety precautions when operating this tool.

3. BEFORE plugging in the tool, BE SURE that the outlet voltage supplied is

within the voltage marked on the tool's data plate, DO NOT use "AC only"

rated tools with a DC power supply,

4. DO NOT expose tools to rain or wet conditions or use electric tools

in wet or damp locations. Water entering an electric tool will increase

the risk of electric shock.

5. If operating an electric tool in damp locations is unavoidable,

ALWAYS USE a Ground Fault Circuit Interrupter to supply power to

your tool. ALWAYS WEAR electrician's rubber gloves and footwear

in damp conditions.

6. When operating a power tool outside, ALWAYS use an outdoor extension

cord marked "W-A" or "W". these cords are rated for outdoor use and

reduce the risk of electric shock.

7. INSPECT tool cords for damage. Have damaged tool cords repaired at

a Sears Service Center. BE SURE to stay constantly aware of the cord

location and keep it well away from the spinning cutting lines.

8. DO NOT abuse the cord. NEVER use the cord to carry the tool by or

to pull the plug from the outlet. Keep cord away from heat, oil, sharp

edge or moving parts. Replace damaged cords immediately. Damaged

cords increase the risk of electric shock.