Operator`s manual

KNOWYOURTRIMMER/EDGER(Fig. 2)

Your trimmer/edger has a precision built

electric motor and it should only be

connected to a 120-volt, 60 HzAC ONLY

power supply (normal household current).

The trimmer should always be used with a

GFCI (Ground Fault Circuit Interrupter) outlet.

DO NOT operate this trimmer on

direct current (DC). The large voltage

drop would cause a loss of power and

the motor would overheat.

If the trimmer does not operate when

plugged into correct 120-volt.60 Hz AC-

ONLY outlet, check the power supply.

The trimmer comes with a 12-in. pigtail

power cord and should be plugged

into a proper extension cord,

Motor

Housing

Handle Rotation

Button

Auxiliary X

Handle

Trigger

Switch

Handle

Cord

Retention

Hook

Pigtail

Power

Cord

AUXllla

Handler_nob

Height Adjustment

Fig. 2

rrlmmer Head

PIGTAIL POWER CORD (Fig. 3)

Your edger trimmer has a 12-inch pigtail power cord. This cord must be attached

to a proper extension cord (see page 7).

Remove the plug guard from the pigtail power cord (see Fig. 3). Make a loop in

the extension cord. Push loop through hole in the handle (see Fig. 3a). Fasten

loop around cord retention hook. Plug trimmer's power cord into extension cord

plug (see Fig. 3b).

Fig. 3

Fig. 3b