Owner's Manual

28212 Manual_Revised_07-0713 Page 7
• Extension cords 100-ft. or longer are not recommended.
• A smaller wire gauge size has greater capacity than a larger number
(14-gauge wire has more capacity than 16-gauge wire; 12-gauge wire has
more capacity than 14-gauge). When in doubt use the smaller number. When
operating a power tool outdoors, use an outdoor extension cord marked
“W-A” or “W”. These cords are rated for outdoor use and reduce the risk of
electric shock.
CAUTION: Keep the extension cord clear of the working area. Position the
cord so that it will not get caught on lumber, tools, or other obstructions while
you are working with a power tool.
WARNING: Check extension cords before each use. If damaged, replace
them immediately. Never use a tool with a damaged cord, since touching the
damaged area could cause electrical shock, resulting in serious injury.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols.
V ......................................................Volts
A.......................................................Amps
Hz.....................................................Hertz
W......................................................Watts
min...................................................Minutes
...............................................Alternating current
..............................................Direct current
….............................................No-load speed
…...............................................Class II construction, Double Insulated
.../min...............................................Revolutions or Strokes per minute
.............................................. Indicates danger, warning or caution. It means
attention! Your safety is involved.
SERVICE SAFETY
• If any part of this router is missing or should break, bend, or fail in any
way; or should any electrical component fail to perform properly: shut off the
power switch and remove the router plug from the power source and have the
missing, damaged, or failed parts replaced before resuming operation.
• Tool service must be performed only at a Craftsman Parts and Repair
Center. Service or maintenance performed by unqualified personnel could
result in a risk of injury.