Owner's Manual

28212 Manual_Revised_07-0713 Page 16
OPERATION
ROCKER “ON/OFF” SWITCH (Fig. 3)
Your palm router motor is turned
“ON” and “OFF” with the rocker
switch located on the top cap of
the motor housing.
The left side of the rocker
switch (as you face it) is
marked “I” for “ON” and the
right side (as you face it) is
marked “O” for “Off.”
To turn the motor “ON”
Push the rocker switch to the
left side marked “I”
To turn the motor “OFF”
Push the rocker switch to the right side marked “O”
1.
Always hold the router and cutting bit away from the workpiece when turning
the toggle switch “ON.”
2.
Contact the workpiece with the router and cutting bit only after the router
has fully reached the selected speed.
3.
Remove the router and cutting bit from the workpiece only after turning the
router motor “OFF” and after the cutting bit has come to a complete stop.
SOFT START FEATURE
The soft-start feature minimizes torque twist by limiting the speed at which the
motor starts. This increases the motor’s life.
LED WORKLIGHTS (Fig. 4)
Your palm router motor has
2 built-in worklights located
around the collet/nut to
provide high visibility of the
workpiece when cutting.
These lights are always “ON”
when the rocker switch is in
the “ON” position.
Fig. 3
Fig. 4
LED worklight