Owner's Manual

28212 Manual_Revised_07-0713 Page 14
PRODUCT SPECIFICATIONS
Rating 6.5 Amps
No load Speed 15000-28000RPM
Peak HP 1.25
Input 120-volts, 60Hz AC
Collets/Nuts and Cutting Bit Shank Diameters 1/4 in.
Base Diameter 3-5/8 in.
Sub Base Opening (Diameter for cutting bit use) 1-1/2 inches
Depth of Cut 1 inch (25.4mm)
NOTE: Before attempting to use your router, familiarize yourself with all of the
operating features and safety requirements.
Your palm router has a precision-built electric motor, which should only be
connected to a 120-volt, 60-Hz AC ONLY power supply (normal household
current). Do not operate on direct current (DC). This large voltage drop will cause
a loss of power and the motor will overheat. If the router does not operate when
plugged into a correct 120-volt, 60-Hz AC ONLY outlet, check the power supply.
This router has a10-ft., 2-wire power cord (no adapter needed).
This Palm Router has the following features:
1. 6.5 Amp, 1-1/4 peak HP, variable-speed motor runs at 15,000 to 28,000
RPM (no-load speed).
2. Variable Speed Dial for matching the motor speed to the workpiece material
and bit size.
3. Micro-adjust knob with scale cast in the motor housing for easily adjusting
the cutting height.
4. Compact motor housing constructed of Cast Aluminum / High Density
Nylon /Overmold for strength and user comfort.
5. 2 LED worklights provide high visibility of the bit and workpiece.
6. Depth scale for accurate set-up
7. Spindle lock for easy, one-wrench bit changes.
8. 1/4-in. self-releasing collet/nut.
9. Detachable, two-handle base features ergonomically designed handles
with overmold for comfort and maximum control with reduced vibration.
10. 3 integrated circular routing holes in the detachable base for conveniently
routing circles and arcs (radii: 2-inch, 2-1/2-inch, 3-inch).
11. Ball bearings throughout the motor for smooth, efficient operation and long life.