Owner's Manual

28212 Manual_Revised_07-0713 Page 11
UNPACKING
WARNING: Your router should never be connected to a power source when
you are assembling parts, making adjustments, installing or removing collets/
nuts or cutting bits, cleaning, or when it is not in use. Disconnecting the router
will prevent accidental starting, which could cause serious personal injury.
1.
Carefully lift the
router, with the 1/4-in. collet/ nut already installed, out of
the storage/carrying case and place it on a stable flat surface.
2.
Locate the following:
• Edge Guide
• Collet/nut wrench
• Detachable two-handle base
3.
Inspect the items carefully to make sure that no breakage or damage has
occurred during shipping. If any of the items mentioned is missing, (refer to
“PARTS LIST” illustration on page 10), return the router to your nearest Sears
store or Craftsman outlet to have the router replaced.
WARNING: If any parts are broken or missing, do not attempt to plug in the
power cord or operate the router until the broken or missing parts are replaced.
Failure to do so could result in possibly serious injury.