Instruction Manual

ASSEMBLY
Process:
• Assemble (2) Screw Levelers in each Leg Weldment.
Some adjustments may be necessary after workbench is
in desired position.
Items Needed:
Leg Weldment (Qty: 4)
Screw Leveler (Qty: 4)
Leveler
Process:
• Place Workbench Top, with top side down. (Use
packaging material to prevent scratches.)
Items Needed:
Frame Weldment (Qty: 2)
Leg
Weldment
Process:
• Assemble Frame Weldment as shown to the bottom of
the Workbench Top following the illustration below and
aligning the pre-drilled holes using (12) 3/8-7 x 1" Hex
screws.
• Tighten screws so frames do not fall, but are still
adjustable.
Frame
Weldment
Frame
Weldment
C
C
B
Process:
• Assemble Leg Spacers (2) into each Frame Weldment by
sliding into frame until spacer snaps into rectangular hole
in Frame Weldment. Repeat 3 times.
• Slide Leg Weldment into Leg Spacers to desired height.
Repeat 3 times. Ensure all legs are at the same position.
Items Needed:
Leg Spacer (Qty: 8)
Leg Weldment (Qty: 4)
5/16-18 x 3-1/2” Carriage Bolt (Qty :4)
5/16-18 Flange Nut (Qty:4)
• Attach front Leg Weldments using (2) 5/16-18 x 3-1/2”
carriage bolt and (2) 5/16-18 ange nuts.
NOTE: Do not assemble carriage bolts to back Leg
Weldment. See Step 4.
Underside of Workbench Top
Back of Workbench
Square Holes on Back
Leg
Workbench
Back
Workbench
Front
3