Owner`s manual

BELT INSTALLATION -
• Install new belt in reverse order of re-
moval.
Make sure belt is in all pulley grooves
and inside all belt guides.
• Install mower in reverse order of re-
moval instructions.
Mandrel Pulle_
Idler Pulley
ey
Mandrel Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is mounted on
the right side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in high-
est gear, then brake must be adjusted.
• Depress clutch/brake pedal and en-
gage parking brake.
• Measure distance between brake oper-
ating arm and nut "A" on brake rod.
• If distance is other than 1-1/2", loosen
jam nut and turn nut "A" until distance
becomes 1-1/2". Retighten jam nut
against nut "A".
• Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary. Con-
tact your nearest authorized service
center/department.
With Parking Brake
"Engaged"
Nut "A"
/,,Jam Nut
oO_Operating Arm
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footrest.
• Remove mower (See 'q-O REMOVE
MOWER" in this section of this manual.)
• Remove belt from stationary idler and
clutching idler.
• Pull belt slack toward rear of tractor.
Remove belt upwards from transaxle
pulley by deflecting belt keepers.
• Pull belt toward front of tractor and re-
move downwards from around engine
pulley.
• Install new belt by reversing above pro-
cedure.
Engine Pulley --
Clutching Idler j
J
Stationary Idler
Transaxle
0
TRANSAXLE GEAR SHIFT LEVER
NEUTRAL ADJUSTMENT
The transaxle should be in neutral when
the gear shift lever is in neutral (N) (lock
gate) position. The adjustment is preset at
the factory; however, if adjustment is
needed, proceed as follows:
• Make sure transaxle is in neutral (N).
NOTE: When the tractor rear wheels move
freely, the transaxle is in neutral.
• Loosen adjustment bolt in front of the
right rear wheel.
• Position the gear shift lever in the neu-
tral (N) position.
• Tighten adjustm,.,_t bolt securely.
NOTE: If additir.:_al clearance is needed
to get to adjustment bolt, move mower
deck height to the lowest position.
24