Manual
Table Of Contents
- THE ROUTER TABLE
- ASSEMBLY INSTRUCTIONS
- Assembly of legs
- Mounting Table to Workbench or Workboard
- Mounting Table to a Workmate
- Identification of Mounting Holes and Screws
- Re-Drilling of Router Base
- Re-Drilling of Insert Plate
- Re-Drilling of Insert Plate and Router base
- Fitting Insert Plate to Table Surface
- Fitting Router to Insert Plate
- Selecting & Fitting Insert Plate Rings
- Fitting Lead-on Pin
- Assembly & Mounting of Tenon Push Block
- Assembly of Safety Dust Guard to Back Fence
- Assembly of Back Fence
- Attachment of Back Fence to Table
- Assembly & Alignment of Mitre Fence
- Fitting of No-Volt Release Switch
- OPTIONAL ACCESSORIES
- OPERATION
- APPENDIX
-31-
Router Table for the Craftsman
Plan for
RYOBI R600, RE600
Routers
4 holes for
M4 M/C
screws
2 holes for
M5 M/C
screws*
* The plate for the CRT/B table
is pre-drilled to accept the two
central fixings M5 M/C screw
59mm
54mm
37mm
44mm
44mm
40mm
FRONT OF CRT TABLE
Position of
Router Handle
Position of
Router Handle
C
C