Instruction Manual

CUTTING HEAD COMPONENTS

Assemble components in the order shown (see gure 13.)

1. Place the spacer and bearing cover (with the lip facing up)

onto the shaft (Figure 13).

2. Align the ats at the center of the plates with the at on the

shaft and slide the line plate onto the shaft. Ensure they

are facing top side up as shown.

3. Place the cutting head bolt so it is sitting in the hex cavity

at the bottom of the cutting head.

4. Looking down at the top of the frame, hold the bolt

head in place with your nger and turn the cutting head

counterclockwise to start the bolt into the shaft.

5. Insert the screwdriver as shown in Figure 12 and tighten

the assembly securely by turning the cutting head

counterclockwise when looking down on the top of the

frame.

NOTE: When nished there should be no gaps between

any of the components.

OPERATION

Improper installation can cause damage to the cutting

head bearings. Follow directions carefully to protect the

string trimmer from damage.

CAUTION

Always make sure you remove the screwdriver from the

head assembly when nished. Failure to remove the

screwdriver could cause injury when the head assembly is

engaged.

WARNING

Figure 13

LINE

PLATE

SPACER

BEARING

COVER

CUTTING

HEAD

BOLT