Instruction Manual

9
ENGLISH
4. Slide the table with the rack onto the column. (Fig. G)
5. Engage the bottom of the rack
17
with the lip of the
column assembly. Tighten the table lock handle
5
to
lock the table to the column assembly.
NOTE: Do not overtighten.
6. Install the rack ring
6
onto the column, so the top lip of
the rack sits into the rack ring
6
. (Fig. H)
NOTE: To avoid column or collar damage, DO NOT
OVERTIGHTEN the set screw
30
.

WARNING: The bottom of the collar MUST NOT be
pushed all the way down onto the top of the rack.
MAKE SURE the top of the rack is under the bottom of
the collar and that there is enough clearance to allow
the rack to freely rotate around the column. Tighten
the set screw
30
using the 3 mm hex wrench.
7. Install the table crank handle
15
onto the worm gear
shaft
31
on the side of the table bracket. (Fig. I)
8. Line up the flat side of the shaft with the set screw
32
in the crank handle and tighten the screw with the
3 mm hex wrench provided. Do not overtighten.

WARNING: Many illustrations in this manual show
only portions of the drill press. This is intentional so
that points being made in the illustrations can be
highlighted. Never operate this drill press without
all guards securely in place and in good operating
condition.
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 25-35 Minutes.

WARNING: For your safety, never connect plug to
power source receptable until all assembly and
adjustment steps are all complete, and you have
read and understood the safety instructions.

WARNING: The drill press is a heavy power tool
and should be lifted with the help of two people
OR MORE to safely assemble it.
Assembling Column To Base (Fig. D)
1. Remove the rack and rack ring from the column
assembly.
2. Position the base
4
on a flat and stable work surface
(must be able to support 100 lbs.).
3. Place the column assembly
26
on the base
4
. Align
the three mounting holes of the column assembly to
the holes of the base.
4. Bag “G” - Locate the three hex bolts
27
from the parts
bag.
5. Place a hex bolt
27
in each hole through the column
assembly and thread into the base. Tighten with a
13 mm wrench or adjustable wrench.
Fig.D
Installing The Table (Fig. E, F, G, H, I)
1. Bag “G” - Install the table lock handle
5
into the hole
at the rear of the table bracket
16
.
NOTE: Install the handle from left to right, so it enters
the non-threaded side of the table bracket first.
2. Bag “G” - Insert the worm gear
28
into the table crank
handle hole
29
from inside of the table bracket
16
.
Make sure the worm gear
28
meshes with the inside
gear.
NOTE: Do not remove the lubrication from this worm
gear.
3. Place the rack
17
into the inside of table bracket
16
as shown in Fig. F, making sure the worm gear
28
in
the table bracket
16
is engaged with the teeth of the
rack
17
and the arrow stamped on the rack is pointing
up.
28
5
16
29
4
26
27
Fig.E
17
5
Fig.G
Fig.F
17
28
16