Use And Care Manual

4
OPERATION
CASTER INSTALLATION (52 INCH)
Items Needed:
5/16 - 18 x .750 Screw (Qty: 16)
1/2-in Socket
Process:
NOTE: Use adequate personnel for this operation.
• Lay the cabinet down on its back. Use packaging
materialtoprotectthepaintnish.
• Mount both swivel casters on the same side of the cart
as the side handle.
• Attach each caster using (4) 5/16 - 18 x .750 screws.
• Wrench tighten all screws.
• Return the cart to its upright position.
• Empty the drawer.
• Fully extend the drawer
REMOVING DRAWERS
Right Release Lever
Left Release Lever
• Push the lever on the right slide down, lift the lever on
the left side up. Pull out drawer to remove.
• Pull slides and slide carrier out to fully extended position
(see illustration).
• Hold the slide on the cabinet while aligning it with the
slide on drawer.
• Slightly insert one side and repeat for the other side.
• Slowly push drawer to its fully closed position to engage
slide.
• Open drawer and reclose to ensure proper operation.
INSTALLING DRAWERS
slide carrier
slide
slide carrier
slide
REMOVING AND INSTALLING SLIDES
•Toremovetheslidefromtheunit,rstremovethe 
drawer.
• After removing the drawer check to see if the unit has
rivets located on the front of the slide. To drill out rivets,
use a 5/32-in drill bit. The rivets will need to be replaced
with 5/32-in rivets.
• To reinstall the slide in the appropriate position in the
unit, align front and back lances with mounting holes in
the side of the unit. Pull towards the front of the unit and
downwards until rivet holes in slide line up with holes in
the unit. The rivets will need to be replaced with 5/32-in
rivets.
• For smooth operation, make sure the drawers are
matched with their original slides.
Drill out rivet