Use And Care Manual

4
OPERATION
• Empty the drawer.
• Fully extend the drawer
REMOVING DRAWERS
Right Release Lever
Left Release Lever
•
To release the drawer from the slides, push the lever
on one side up and on the other side down. Pull out
drawer to remove.
• Pull slides and slide carrier out to fully extended position
(see illustration).
• Hold the slide on the cabinet while aligning it with the
slide on drawer.
• Slightly insert one side and repeat for the other side.
• Slowly push drawer to its fully closed position to engage
slide.
• Open drawer and reclose to ensure proper operation.
INSTALLING DRAWERS
slide carrier
slide
slide carrier
slide
REMOVING AND INSTALLING SLIDES
• Toremovetheslidefromtheunit,rstremovethe
drawer.
• After removing the drawer check to see if the unit has
rivets located on the front of the slide. To drill out rivets,
use a 5/32-in drill bit. The rivets will need to be replaced
with 5/32-in rivets.
• To reinstall the slide in the appropriate position in the
unit, align front and back lances with mounting holes in
the side of the unit. Pull towards the front of the unit and
downwards until rivet holes in slide line up with holes in
the unit. The rivets will need to be replaced with 5/32-in
rivets.
• For smooth operation, make sure the drawers are
matched with their original slides.
Drill out rivet