Instruction Manual

5
ENGLISH

WARNING: Unplug the trimmer before
attempting to attach the guard, edge guide or handle.
Never operate tool without guard firmly in place. The
guard must always be on the tool to protect theuser.
Attaching the Guard (Fig. C, D)

WARNING: NEVER OPERATE TRIMMER
WITHOUT GUARD FIRMLY IN PLACE.
1. Turn the trimmer upside down so that you are looking
down at the spool
10
.
2. Remove the screw from the guard with a
crossheadscrewdriver.
3. Turn the guard
9
upside down and slide it fully onto
the motor housing
8
. Make sure the tabs
11
on the
guard engage the ribs
12
on the motor housing as
shown in Fig. C. The locking tab should have snapped
into the housingslot.
4. Continue to slide the guard on until you hear it “snap”
intoplace.
5. Insert the guard screw as shown in Fig. D to complete
the guardassembly.
6. Once the guard is installed, remove the covering from
the line cut-off blade, located on the edge of theguard.
Fig. C
10
8
12
12
9
8
11 11
Fig. D
Attaching the Auxiliary Handle (Fig. E, F, G)
1. To attach the handle
6
, press in on the buttons
15
on
both sides of the upper housing as shown in Fig. E.
2. Position the handle as shown in Fig. F, matching up the
grooved side of the handle with the grooved button.
Partially push the handle on so that it will hold the
buttons in when you release them with your hand.
3. Push the handle completely onto the housing and
position it slightly until it “snaps” into place.
4. To adjust the handle up or down, press in on the
button and raise or lower the handle as shown in Fig. G.
5. The handle should be adjusted so that your front arm is
straight when the trimmer is in the workingposition.
Fig. E
15
Fig. F
6
Fig. G
15