Use and Care Guide

16
Starting the system for the rst time
1. Press
button, to activate the heater to display outlet temperature.
2. With the water running through the unit, press
or to adjust the temperature.
Freezing Temperatures
If the ambient temperature falls below 32°F (0°C), protect the heater from potential damage. Power off the unit using the dedicated circuit
breaker on the main electrical panel. Open a faucet slightly to cause water to flow continuously through the device at a very low rate,
without heating. Restore power to the unit when temperature condition is normal.
If the water inside the heater freezes, it can cause damage that is not covered by warranty. If you suspect water has frozen within
the unit, do not turn it on until you are sure the frozen water has melted, and there are no leaks in the unit. It is recommended to contact a
qualified electrician or the manufacturer for service in this situation.
118
º
F
temp
Digital temperature display
Temperature setting Buttons
Power Button
Cold water inlet
Hot water outlet
(to be connected to the main hot water pipe)