Owner's Manual

Programming

Your garagedoor opener has been programmed at the factory to operate with your remote control. The remote control can be

programmed using the door control or the garagedoor opener. To program additional remote controls refer to the instructions provided

with the additional remote controls.

PROGRAMA REMOTEUSINGTHE LEARNBUTTON TO ADD, REPROGRAM,ORCHANGEA REMOTECONTROL/

KEYLESSENTRYPIN USINGTHESMARTCONTROLPANEL

1. Pressand releasethe Learn

button on the garagedoor opener. The

Learn indicator light will glow steadily

for 30 seconds.

2. Within 30 seconds, press and hold the

button on the remote control.

1. Pressthe navigation button below

"MENU"to view the Featuresmenu.

2. Usethe navigation buttons to scroll to

"PROGRAM"and press the navigation

button under_ to continue.

3. Releasethe button when the garage

door opener light blinks. It has learned

the code. If light bulbs are not installed,

two clicks will be heard.

When replacing the light lens cover, ensure the antenna wires are

hanging straight down.

3. Select "REMOTE"or "KEYPAD"to

program from the program menu.

Press_ to continue.

4. Pressthe button on the remote

control that you wish to operate your

garagedoor.

Enter a 4-digit personal identification

number (PIN) of your choice on the

keyless entry keypad.Then press the

ENTERbutton.

? ? ? ?

To Erase the Memory

ERASEALL REMOTECONTROLSAND KEYLESSENTRIES

1. Pressand hold the learn button on garagedoor opener until the

learn LEDgoes out (approximately 6 seconds). All remote

control and keyless entry codes are now erased.

Reprogram any accessory you wish to use.

ERASEALLDEVICES

1. Pressand hold the learn button on garage door opener until the

learn LEDgoes out (approximately 6 seconds).

2. Immediately press and hold the learn button again until the

learn LEDgoes out. All codes are now erased.

Reprogramany accessoryyou wish to use.