Owner's Manual

Features(Continued)
USING YOURGARAGEDOOROPENER
The garagedoor opener can be activatedthrough a wall-mounted
door control, remote control, wireless keyless entry or
AssureLinkTM accessory.
When the door is closed and the garagedoor opener is activated
the door will open. If the door senses an obstruction or is
interrupted while opening the door will stop. When the door is in
any position other than closed and the garage door opener is
activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction
interrupts the sensor beam the garagedoor opener lights will
blink 10 times. However,you can close the door if you hold the
button on the door control or keylessentry until the door is fully
closed. The safety reversing sensors do no effect the opening
cycle.
The safety reversing sensor must be connected and aligned
correctly before the garagedoor opener will move in the down
direction.
Door Control
USINGTHE DOORCONTROL
Push Bar
Navigation
Buttons
LIGHT
Button
Screen
Motion
Sensor
Push Bar
Pressthe push bar to open or close the door.
LightButton
Pressthe LIGHT button to turn the garagedoor opener lights on
or off. When the lights are turned on they will stay on until the
LIGHT button is pressedagain, or until the garage door opener is
activated. Oncethe garagedoor opener is activatedthe lights will
turn off after the specified period of time (the factory setting is
4-1/2 minutes). The LIGHTbutton will not control the lights when
the door is in motion. The duration of the light timing can be
adjusted using the door control.
NavigationButtons
Usethe navigation buttons to make selections and program
features.
Screen
The screen will display the time and temperature until the menu
button is pressed, and then it will display the menu options. If
there is a problem with the garagedoor opener the screen will
display the Diagnostic Code.Referto the Troubleshooting section.
The followingfeaturesare accessiblethroughthe screenusing
the navigationbuttonsonthe Smart ControlPanel:
LEARNA DEVICE
Any compatible remote controls, wireless keylessentry, or
AssureLinkTM accessories can be programmed to the garagedoor
opener by accessing the menu and using the navigation buttons
on the Smart Control Panel.
Lock
The LOCKfeature is designed to preventactivation of the garage
door opener from remote controls while still allowing activation
from the door control and keylessentry. This feature is useful for
added peaceof mind when the home is empty (i.e. vacation).
Timer-to-Close(TTC)
DO NOTenableTTC if operating a one-piecedoor. TTCis to be
used ONLYwith sectional doors.
Factory default is set to off. TTC can be set to automatically close
your garagedoor from the fully open position after a specified
period of time (1, 5, 10 minute intervals). The Smart Control Panel
also has a custom setting up to 99 minutes. The garage door
opener will beep and the lights will flash before closing the door.
The screen on the door control will display the status of the TTC
such astime to close, paused,or an error. If the door encounters
an obstruction while closing, the garagedoor opener will make a
second attempt to close the door. If the obstruction has not been
cleared after the second attempt, the garagedoor opener will
reverse open, stop and WILL NOTclose until the obstruction has
been cleared.TTCWILL NOTwork if the garage door opener is
operating by battery power or if the safety reversing sensors are
misaligned. This feature is NOTintended to be the primary
method of closing the door. A keyless entryshouldbe installed
in the event of an accidental lockoutwhen usingthis feature.
AUTOMATICLIGHT
Motion Sensor
Factory default is set to on. This feature will automatically turn on
the garagedoor opener lightswhen motion is sensed.The lights
will come on for the set period of time, then shut off.
The lightswill turn on when someone enters through the open
garage door and the safety reversing sensor infrared beam is
broken.
If using the garagedoor opener light as a work light disable the
Automatic Light Feature,otherwise the light will turn off
automatically if you are beyond the rangeof the sensor.
32