Owner's Manual

Install the Door Control (Continued)
WIRETHE DOORCONTROLTO THEGARAGEDOOROPENER
(FIGURE4)
Pre-wired installations:When wiring the door control to the
garage door opener makesure you use the same wires that are
connected to the door control.
1. Run the white and red/white wire from the door control to the
garagedoor opener. Attach the wire to the wall and ceiling with
the staples (not applicable for gang box or pre-wired
installations). Do not piercethe wire with the staple as this may
cause a short or an open circuit.
2. Strip 7/16 inch (11 mm) of insulation from the other end of the
wire nearthe garage door opener.
3. Connect the wire to the red and white terminals on the garage
door opener.
Figure4 DoorControlConnections
Strip wire 7/16" (11 mm)
ro insert or release wire, push
in tab with screwdriver tip
INSTALLATION STEP 12
Install TheProtectorSystem®
IMPORTANTINFORMATIONABOUTTHESAFETYREVERSING
SENSOR
The safety reversing sensor must be connected and aligned
correctly before the garagedoor opener will move in the down
direction.
The sending sensor (with an amber LED)transmits an invisible
light beam to the receiving sensor (with a green LED). If an
obstruction breaksthe light beam while the door is closing, the
door will stop and reverseto the full open position, and the
garage door opener lights will flash 10 times.
NOTE:For energy efficiency the garagedoor opener will enter
sleep mode when the door is fully closed. Thesleep mode shuts
the garage door opener down until activated. The sleep mode is
sequenced with the garage door opener light bulb; as the light
bulb turns off the sensor LEDswill turn off and wheneverthe
garage door opener lights turn on the sensor LEDs will light. The
garage door opener will not go into the sleepmode until the
garage door opener has completed 5 cycles upon power up.
When installing the safety ing sensors check the following:
Besure power is NOTconnected to the garagedoor opener
BEFOREinstalling the safety reversing sensor.
To prevent SERIOUSINJURY or DEATHfrom a closing garage
door:
• Correctly connect and align the safety reversingsensor. This
required safety device MUST NOTbe disabled.
• Install the safety reversing sensor so beam is NO HIGHER
than 6" (15 cm) above garagefloor.
• Sensors are installed inside the garage,one on either side of
the door.
• Sensors are facing each other with the lensesaligned and the
receivingsensor lens does not receivedirect sunlight.
• Sensors are no more than 6 inches (15 cm) above the floor and
the light beam is unobstructed.
Safety Reversing Sensor
6" (15 cm) max. above floor
Invisible Light Beam
Protection Area
Safety Reversing Sensor
6" (15 cm) max. above floor
Facingthe doorfrom inside the garage
23