Owner's Manual

ConnectDoorArm to Tro//ey(Continued)
ALL0NE-PIECEDOORS
IMPORTANT."Thegroove on the straight door arm MUST face
away from the curved door arm (Figure 5).
1. Closethe door. Disconnectthe trolley by pulling the emergency
releasehandle.
2. Fastenthe straight door arm and the curved door arm together
to the longest possible length (with a 2 or 3 hole overlap).
3. Attach the straight door arm to the door bracket using the
5/16"x1-1/4" clevis pin. Secure with the ring fastener.
4. Attach the curved door arm to the trolley using the 5/16"x1"
clevis pin. Secure with the ring fastener.
5. Pull the emergency release handletoward the garagedoor
opener until the trolley releasearm is horizontal.
Figure5
CORRECT
INCORRECT
Trolley
Pulley Stop Bolt Inner
Trolley
Outer
Trolley
Door
Bracket
Ring
Ring Nuts Fastener_
Fastener 5/16"-18
strai0ht Q
DoorArm Lock
Washers-------_
, 5/16"
Clevis Pin
5/16"x 1-1/4"
DoorArm
Bolts
5/16"-18x7/8"
Emergency
Release Handle
Clevis Pin
5/16"xl"
INSTALLATION STEP 10
Attach the Warning Labels
1. Attach the entrapment warning label on the wall near the door
control with tacks or staples.
2. Attach the manual release/safetyreversetest label in a visible
location on the inside of the garage door.
21