Owner's Manual

ManualsBrandsCraftsman ManualsGarage Door OpenersCraftsman AssureLink Internet 3/4 HP DC Belt Drive Garage Door Opener DieHard Battery Backup, No Annual Fees

INSTALLATION STEP 6

Install the Lights

1. Pressthe releasetabs on both sides of lens. Gentlyrotate lens

back and downward until the lens hinge is in the fully open

position. Do not removethe lens.

2. Insert an A19 incandescentor compact fluorescent light bulb

(100 watt maximum), into the light socket. The lights will turn

ON and remainlit for approximately 4-1/2 minutes when power

is connected. Then the lights will turn OFF.

3. Reversethe procedure to close the lens.

4. If the bulbs burn out prematurelydue to vibration, replacewith

a garage door opener bulb. UseA19, standard neck garage

door opener for replacement.

NOTE: Useonly standard light bulbs. The use of short neck or

speciality light bulbs may overheatthe endpanel or light socket.

To prevent possible OVERHEATINGof the end panelor light

socket:

• UseONLYA19 incandescentor compact fluorescent light

bulbs.

• DONOTuse incandescentbulbs larger than IOOW.

• DONOTuse compact fluorescent light bulbs larger than

26W (IOOW) equivalent.

• DONOTuse halogen bulbs.

• DONOTuse short neck or specialty light bulbs.

Release Tab

Compact Fluorescent --

Light Bulb

]_ or

100Watt(Max)

' Standard Light Bulb

100 Watt(Max)

StandardLightBulb

Hinge

Compact Fluorescent

Light Bulb

INSTALLATION STEP 7

Attach the Emergency Release Rope and Handle

1. Thread one end of the rope through the hole inthe top of the

red handleso "NOTICE"reads right side up as shown, Secure

with an overhand knot at least1" (2.5 cm) from the end of the

ropeto prevent slipping,

2. Thread the other end of the rope through the hole inthe release

arm of the outer trolley.

3. Adjustrope lengthso the handle is 6 feet (1.83 m) above the

floor, Ensurethat the rope and handle clear the tops of all

vehicles to avoid entanglement,Secure with an overhand knot,

NOTE:If it is necessaryto cut the rope, heat sealthe cut end with

a match or lighter to prevent unraveling.

To prevent possible SERIOUSINJURYor DEATHfrom a falling

garagedoor:

• If possible, useemergency releasehandleto disengage

trolley ONLYwhen garagedoor is CLOSED.Weak or broken

springs or unbalanceddoor could result in an open door

falling rapidly and/or unexpectedly.

• NEVERuse emergency releasehandle unless garagedoorway

is clear of persons and obstructions.

• NEVERuse handle to pull door open or closed. If rope knot

becomes untied, you could fall.

Trolley

Release Arm 1

Overhand

Emergency _ Knot

Release Handle _