Owner's Manual

ASSEMBLY STEP 4

Install the Belt

1. Pull the belt around the idler pulley and toward the trolley.

The ribbed side must contact the pufley.

2. Hookthe trolley connector into the retaining slot on the trolley

as shown.

3. With the trolley against the screwdriver, dispensethe

remainder of the belt along the rail length toward the motor

unit and around the sprocket. The sprocket teeth must engage

the belt.

4. Checkto make sure the belt is not twisted. Connectthe trolley

threaded shaft with the master link, as illustrated:

• Push pins of master link bar through holes in end of belt

and trolley threaded shaft.

• Push master link cap over pins and past pin notches.

• Slide clip-on spring over cap and onto pin notches until both

pins aresecurely locked in place.

5. Insert the trolley threaded shaft through the hole in the trolley.

Besure the belt is not twisted.

To avoid possible SERIOUSINJURYto fingers from moving

garagedoor opener:

• ALWAYS keep hand clear of sprocket while operating opener.

• Securely attach sprocket cover BEFOREoperating.

Trolley Connector

Belt Sprocket

Idler

Pulley

Trolley

Connector

Slot

Threaded

Shaft

Master Link

Clip-On Spring

Master

Link Cap

Notch

Trolley Master

Threaded Link Bar

Shaft

[©

Trolley Threaded Shaft

HARDWARESHOWN ACTUALSIZE

Master Link