Owner's Manual

Table Of Contents

• Periodically the surfaces should be cleaned with a mild

detergent and water.

C Grease and oil can be removed with most standard cleaning

fluids. For safety, use a nonflammable cleaning fluid.

C Auto wax will preserve the unit's luster finish. Apply the wax as

to a car. The wax will also help protect the unit against

scratches.

Flange

underneath

• Place the workbench in its upright position.

• Position (C) centered against back of workbench top (D), with

flange underneath.

• Mark center of mounting hole locations using the holes in

flange of (C) as a template. Make sure (C) does not move.

• Remove (C) for access.

• Drill 1/8" pilot holes 1/2" deep in mounting hole locations.

• Reposition (C) on workbench top (D).

• Attach using (DD).

Flanges

point out

Front

Back

DD (15) 8'

DD (11) 6'

1-1/2 inches

38 mm

• Square the unit and wrench tighten all fasteners.

STEP 5:

• Position frame assembly on workbench top, (D) as desired.

Note: The back of the work bench frame must be at least 1-1/2

inches (38 mm) from the back of the workbench top (D).

• Mark centers of mounting holes.

• Move workbench assembly for access.

• Drill 1/8" pilot holes 1/2" deep in mounting hole locations.

• Reposition workbench assembly on workbench top (D).

• Attach using (DD).

Note: Additional fasteners may be used to attach workbench top

through holes in side support if desired. (Not supplied)

OPERATION

MAINTENANCE

Leveling Foot Adjustment

• Adjust leveling foot to

desired position with flat

head screwdriver or 7/16

open end wrench as shown.