Owner's Manual

Table Of Contents

STEP (1):

• Assemble (2) (EE) in each (A). Some adjustments may be

necessary after workbench is in desired position.

STEP (2):

For 6' Workbench skip this step

• Assemble (1) (B) and (1) (D), as shown, using (8) (AA), (8)

(BB), and (8) (CC).

• Repeat for other top support rail.

• Finger tighten.

EE(4)

AA(16) BB(16) CC(16)

(EE)

on top

Flanges

point in

Back

Front

Notches

on top

STEP (3):

• Place workbench top (Purchased Separately), (D) with top side

down. (Use packaging material to prevent scratches.

Note: The rail (B) with the label should be placed toward the front

of the unit with the label upside down.

• Assemble (2) (A) and (2) (B), as shown, using (8) (AA), (8)

(BB), and (8) (CC). Flanges of (B) should point in. Notches

should be up.

• Finger tighten.

STEP (4):

• Attach remaining (B) in top back set of holes in (2) (A) as

shown, using (4) (AA), (4) (BB), and (4) (CC). Flanges of (B)

should point out.

• Attach remaining hardware in bottom holes in top front set of

holes as shown in illustration.

• Finger tighten.

AA(8)

BB(8)

CC(8)

AA(6)

BB(6)

CC(6)

ASSEMBLY