Instruction Manual

Recommended Drawer Configuration

STEP (5):

Note: Before inserting each drawer, fully extend the frame slides

for that drawer.

• Insert the drawer slides (Gd) into the workbench slides (Gu)

and push all of the way to the back.

• Pull the drawer open until it stops to ensure proper assembly.

• Repeat for the rest of the drawers.

• Square the unit and adjust for frame for drawer alignment and

smooth operation.

• Remove enough drawers to reach all fasteners. (See drawer

removal and installation instructions.)

• Wrench tighten all fasteners.

• Reinstall drawers. (See drawer removal and installation

instructions.)

• Empty the drawer.

• Fully extend the drawer.

Release

• To reinstall, carefully align

the slides and slowly push

the drawer into the unit until

the drawer stops.

Lever Style - Lift or lower (depending on the

slide) the release lever on both sides, (this

allows the slides to ride over the stops.) Pull

out to remove.

Tab Style - Depress the release tabs on

both sides, (this allows the slides to ride over

the stops.) Pull out to remove.

REMOVING AND INSTALLING DRAWERS:

C Lubricate the slides with grease or equivalent, (twice yearly.)

C Periodically the drawer fronts, drawer trim, and other surfaces

should be cleaned with a mild detergent and water.

C Auto wax will preserve the unit's luster finish. Apply the wax as

to a car. The wax will also help protect the unit against

scratches.

C Grease and oil can be removed with most standard cleaning

fluids. For safety, use a nonflammable cleaning fluid.

OPERATION

MAINTENANCE

Leveling Foot Adjustment

• Adjust leveling foot to

desired position with flat

head screwdriver or 1/2"

open end wrench as shown.