Instruction Manual

3
1.5"
(38 mm)
A
GG
GG(2)
STEP (1):
• Ensure that the leveling screws on the work bench are
extended to at least (1.5) inch, (38 mm). See operation
section; Leveling foot adjustment.
• Assemble (2) adjustment feet (GG) in side panel (A). Make
sure both leveling feet (GG) are fully retracted into A.
Workbench Top
removed for clarity
(A) fits in notch in
workbench rail
A
B
STEP (2):
Note: Drawer kit may be installed on left or right side of
workbench. Installation is shown on right side.
• Lean side panel (A) at an angle to fit under the rails on the
workbench.
• Line up the side panel with notches on the top rails of the
workbench. Rotate side panel (A) to the upright position inside
notches.
• Attach side panel (A) using (6) bolts (AA), (6) washers (BB),
and (6) nuts (CC).
• Attach rail (B), as shown, using (4) bolts (AA), (4) washers
(BB), and (4) nuts CC.
• Adjust bench to desired height. (See operation section;
Leveling foot adjustment.)
AA(10)
BB(10)
CC(10)
ASSEMBLY