! SEARS OWNER'S MANUAL Model No. 390.307060 CAUTION: Read and Follow All Safety Rulesand Operating Instructions Before FirstUse of ThisProduct. I:RRFTSMRN° BATTERY OPERATED BACKUP SUMP PUMP • Safety Instructions Save ThisManual For Future Reference. • Operation • Installation • Troubleshooting • Repair Parts Sears, Roebuck and Co., Haffman Estates, IL 60179 PRINTED IN USA U.S.A.
CONTENTS Introduction/Warranty ........................................................ 2 IMPORTANT SAFETY INSTRUCTIONS for BATTERY CHARGER [AWARNING] Risk of electrical shock, fire, or explosion. Read all instructions in owner's manual and on charger, pump, and battery before using battery charger. Safety ................................................................................... 2 Performance ........................................................................ 3 Charger Operation .....
BATTERY BACKUP SYSTEM INSTALLATION AND OPERATION [_, WARNINGIHazardous voltage. Can cause severe or fatal electrical shock. Do not plug in or unplug battery charger while standing on a wet floor or in water. Be sure one hand is free when plugging in or unplugging charger. If basement floor is wet, fore walking on floor. p disconnect power to basement be- i 1_, CAUTION ]Risk of flooding. Do not run pump dry. To do so will damage seals and can cause leaking and property damage. 2.
[A CAUTION] Risk of pinching hands or fingers. a band injury from a collapse of plumbing, support 5. Hold the coupling (Key No. 6, Page 9) with the channel locks, insert the screwdriver into the tee for leverage and tighten the tee with the screwdriver. Finish with the tee in a straight up and down (vertical) position. To avoid the pipe above the separation before cutting or disassembly. 4. Lift the primary pump and discharge pipe assembly out of the sump. [AWARNINGIRLsk of electrical shock. 6.
Trial Assembly of Double Sump 4.Take the tee assembly off of the primary discharge pipe. Do not take the tee off of the threaded assembly. Pump Assembly in Pit: 5. Clean an the PVC pipe ends with the PVC cleaner. 1. Connect the pump discharge pipe to the exterior discharge pipe with the rubber coupling and clamp kit (Key No. 2, Page 9). Do not tighten the clamps until all the final adjustments are complete. See Figure 3. NOTICE: For 1-1/2" discharge pipe, remove tion of hose from the rubber coupling.
CHARGER/BATTERY INSTALLATION 4. With the charger properly connected and plugged in, the panel on the front of the charger will show one of the following conditions (See Figure 6). NOTICE: An alarm, located in the junction box, automaticall)" sounds when the system runs if the alarm is in the "Enable" position. The alarm is silenced when the alarm switch is in the "Disable" position. LApply two pieces of two-sided tape (provided, Key No. 11, Page 9) to the back of thejuoction box.
3. Continuous Yellow LED llglht: C0nstant voltage charge stage. Cells are being equalized. Test the Assembly: 1. Plug the primary pump into a properly grounded outlet. 2.FLU the sump with water Check for leaks. 3-prong to start the primary 4. Green LED light: Roat charge stage. Battery terminal voltage has been regulated and system is ready for use. Charging has stopped. pump. 5. Recycle charge stage. Charger will automatically initiate a charge cycle that begins with the prequallflcation test stage.
Figure 7 - Battery Hold-down Strap Threading BATTERY MAINTENANCE [_,WARNING ] Severe sulfuric acid. Avoid burn contact hazard. A filled battery contains with skin, eyes or clothing. NOTICE: To protect battery ease from chipping and gouging, do not let battery sit on concrete floor. Install battery on a shelf or protective pad (plywood, 2x4s, etc.). Always install battery in a dry location that is protected from flooding. Follow the battery manufacturer's maintenance and safe use of battery.
Craftsman Battery Backup Sump Pump Model 390.307060 I _1 9A 9B I I I I i// 12 3465 0799 SRS REPAIR PARTS LIST Key No. 1 2 3 4 5 6 7 8 9 9A 9B 10 11 12 13 14 Part No.
lO
SEARS OWNER'S MANUAL CRAFTSMAN° BATTERY OPERATED BACKUP SUMP PUMP Model No. 390.307060 For the repair or replacementpartsyou need Call7 am - 7 pro, 7 days a week 1-800-366-PART (1-800-366-7278) Foris-homemajorbrandrepairservice Call24 hoursa day,7 daysa week The model number of your Backup Sump Pump will be located on the pump, not the battery charger.
