Operator`s manual

WARNING: Make certain that the unit is disconnected from
power source before attempting to service or remove any
component.
CLEANING
Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool Keep the drums clean. Dirt on drums
will cause poor tracking and beti slippage. Periodically empty
the dust collection bag.
Be certain motor is kept clean and is fraquentiy vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts and
plastic guards.
LUBRICATION
The shielded ball bearings in this tool are permanently
lubricated at the factory.They require no further lubrication.
• When operation seems stiff, a fightcoat of paste wax
applied to the table will make it easier to feed the work
while finishing.
• Do not apply wax to the belt platen. Belt could pick up wax
and deposit it on wheels causing belt to slip.
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, have it
replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list to
order parts.
Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician. Repair
service is available at your nearest Sears store,
SYMPTOM
Motorwillnot start
,,lotor will not start;
fuses blown or circuit
breakers are tripped
Motor fails to develop full
)ower (power output of
motor decreases ra.pidly
with decrease in voltage
at motor terminals)
Motor overheats
victor stalls (resulting in
blown fuses or tripped
circuit breakers)
Machine slows down
while operating
Abrasive belt runs off top
wheel
Dust collection
not working
POSSIBLE CAUSE(S)
1. Low voltage
;2. Open circuit in motor or loose
connections
3. Defective switch
4. Defective capacitor
1. Short cimuit in line cord or plug
2. Short ci_uitin motor orloose
ccnne_on$
3, lncorrectfuses or slmuit braake_ in
power[ine
1, Power line overloaded with lights,
appliances and other motors
2. Undersize wires or circuits too long
;3. General overloading of power
company's facilities
Motor overloaded
1. Short circuit in motoror loose
connections
2. Low voltage
3. Incorrect fuses or cimuit breakers in
power line
4. Motor overload
Applying too much pressure to workplace
Not tracking properly
1, Dust collection bag full
2. Belt loose or broken
3. impeller loose or broken
CORRECTIVE ACTION
1. Check power line for proper voltage
2. Inspect all lead connections on motor for loose or
open connection
3. Replace switch
4, Replace capacitor
1. Inspect line cord or plug for damaged insulation and
shorted wires
2. Inspect al! lead connections on motor for loose or
shorted terminals or worn insulation on wires
3. Install correct fuses or circuit breakers
1. Reduce the load on the power line
2. Increase wire sizes, or reduce length of wiring
3. Request a voltage check from the power company
Reduce load on motor
1, Inspect connections in motor for loose or shorted
terminals or worn insulatipn on lead wires
2. Correct the low line voltage conditions
3. Install correct fuses or circuit breakers
4. Reduce load on motor
:Ease up on pressure
See operation "Adjusting Belt Tracking"
1. Empty dust collection bag
2. Replace belt
3. Raplaoe impeller
9