Operator`s manual

KzgntPax 9/10/2003 i0:38 PAGE 6/41 RightFax
ATTACH BELT TABLE
Refer to Figures 9 and 10.
• Position belt assembly approximately 30" from horizontal,
• Place locking nut Into trunnion groove.
• Position table and nut over the slide on the pivot bracket.
• Slide handle _mugh the platen and thread into locking nut.
(Model 21508 has sleeve with handle).
• Using a combination square, set the table perpendicular to
the bell Attach pointer with screw and set pointer at 0".
• Make sure thai the gap between the belt and bolt table is
'/_," or less Tighten handle securely.
• Position belt assembly upright and secure in position.
Figure 9 - Attach Belt Table
- Check Squareness o :Table to Belt
ATTACH BELT DUST CHUTE
Refer to Figure 11.
• Mount belt dust chute to p/aten using two pan head screws.
Igure 11 - Attach Belt Dust Chute
ATTACH DUST CHUTE
Refer to Ffguse 12.
• Slide dust chute onto end of chip exhaust. T'_jhtan so'-ew to
secure In _tt[on.
Figure 12 - Attach Dust Chute
ATTACH DUST COLLECTION BAG
Refer to Figure 13, page 6.
• Twist handle to completely open clamp
• Pull arm of dust collection bag through clamp.
• Pull arm of bag and clamp over dust chute. Secure bag in
position using clamp handle.
5