Operator`s manual

Rlghtr&X 9110/2003 10:38 PAGE 5141 RightFaX

Trunnion

Figure 4 - Attach Disc i-able ASSembly

• Using a combination square, set the table perpendicular to

the disc. Attach pointer with screw and set pointer at 0 °.

Figure 5 - Check Squarenes= of Table to Disc

ATTACH BELT PLATEN ASSEMBLY

Refer to Figure 6,

• Slide pivot bracket of belt platen over pivot stop bracket and

secure in position with socket head bolt. Make sure stop

bo!t is between limit stops.

Pivot Stop Bracket

Tighten to Secure

Figure 6 - Attach Belt Platen As=embly

A'FFACH DRIVE ROLLER

Refer to Figure 7,

• Slide drive miler over main shaft and secure in position

with set sorew. Make sure set screw tightens against fiat on

shaft.

Model 21508: Posltlon shaft end flush with rotter end.

Modal 21518: Roller is installed at factory,

Figure 7 - Attach Drive Roller

INSTALL ABRASIVE BELT

Refer to Figure 8.

• Pull tension lever up towards idler roller.

NOTE: There may be an arrow on the inside of the belt. The

arrow should point tn the _rection of belt travel to ensure that

the splice in the belt will not come apart.

• Slide belt over the ddve and idler milers; center belt on

milers.

• Push tension lever towards down drive miler to tension belt.

• Rotate belt by hand to sheck tracking. Belt should r_de

centered on drive and idler rollers. Adjust kacking nut as

needed to center belt on rollers

To gNut

Tension Lever

Belt