SANDER Model No. ASSEMBLY Oscillating Spindle SAFETY Operator’s Manual 351.215000 OPERATION MAINTENANCE Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com/craftsman 25759.00 Draft (01/22/08) ESPAÑOL all Safety Rules and Operating Instructions before First Use of this Product. Keep this manual with tool.
• Wear safety glasses complying with United States ANSI Z87.1. Everyday glasses have only impact resistant lenses. They are NOT safety glasses. • Wear face mask or dust mask if operation is dusty. • Be alert and think clearly. Never operate power tools when tired, intoxicated or when taking medications that cause drowsiness. TABLE OF CONTENTS Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
22½″ WARNING: Do not attempt to operate tool until it is completely assembled according to the instructions. SAFETY • Sander can be installed on a workbench or a tool stand (see Recommended Accessories, page 9) using bolts, lock washers and hex nuts. • Figure 2 shows the base dimensions and mounting holes. • Turn machine off if it jams. • Support workpiece with work table. CAUTION: Think safety! Safety is a combination of operator common sense and alertness at all times when tool is being used.
• Check with a qualified electrician if grounding instructions are not understood or if in doubt as to whether the tool is properly grounded. • This tool is equipped with an approved 3-conductor cord rated at 150V and a 3-prong grounding type plug (Figure 6) for your protection against shock hazards. • Grounding plug should be plugged directly into a properly installed and grounded 3-prong grounding-type receptacle, as shown (Figure 6).
EXTENSION CORDS Sander features a large 18″ cast iron table, dust port and onboard storage of durms, inserts and washers. Six sizes of drums are included. Dust port is sized to fit Sears wet/dry vacuums. • The use of any extension cord will cause some drop in voltage and loss of power. • Wires of the extension cord must be of sufficient size to carry the current and maintain adequate voltage. • Use the table to determine the minimum wire size (A.W.G.) extension cord.
The sander can be locked from unauthorized use by locking the switch. To lock the switch: • Turn the switch to OFF position and disconnect sander from power source. • Pull the key out. The switch cannot be turned on with the key removed. NOTE: Should the key be removed from the switch at the ON position, the switch can be turned off but cannot be turned on again. • To replace key, slide key into the slot on switch until it snaps.
TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Motor will not start 1. Low voltage 2. Open circuit in motor or loose connections 3. Defective switch 4. Defective capacitor 1. Check power line for proper voltage 2. Inspect all lead connections on motor for loose or open connection 3. Replace switch 4. Replace capacitor Motor will not start; fuses blown or circuit breakers are tripped 1. Short circuit in line cord or plug 1.
Model 351.
REPLACEMENT PARTS LIST FOR SANDER KEY NO. PART NO. DESCRIPTION 1 2 26019.00 26020.00 3 26021.00 4 26022.00 5 26023.00 Knob Drum Washer (set of 5: ¾″, 1″, 1½″, 2″, 3″) Abrasive Sleeve (set of 6: ½″, ¾″, 1″, 1½″, 2″, 3″) Rubber Drum (set of 5: ¾″, 1″, 1½″, 2″, 3″) Table Inserts (set of 6: ½″, ¾″, 1″, 1½″, 2″, 3″) Table Fan Gasket 5-0.8 x 10mm Flat Head Screw Fan Housing 5mm Flat Washer* 5-0.8 x 12mm Socket Head Bolt* Seal 6003ZZ Ball Bearing* Bearing Retainer Spindle 5-0.
Service Record Craftsman Oscillating Spindle Sander DATE MAINTENANCE PERFORMED REPLACEMENT PARTS REQUIRED 10
NOTES 11
Get it fixed, at your home or ours! Your Home For expert troubleshooting and home solutions advice: www.managemyhome.com For repair – in your home – of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner’s manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters.
