Owner`s manual

MAKING SIGNS USING
CAPITAL LETTERS
"Modern Writing Style"
16. Locate stencil of first letter against
inside fold of stencil cover and up
against tack. (Locating each stencil
the same results in straight work.) Be
sure cutter bit is on center of work
board when stylus is on center of
stencil sheet. Rout first letter. Switch
router off. Pick up handle bar and
place stylus on SPACING DOT at
right of stencil sheet, allowing bit
cutter to rest on wood. (This properly
spaces letters.)
17. Remove stencil of letter just routed
and place stencil of next letter in
place. Loosen work piece and move
work piece to left. Router and
Pantograph will ride on work piece
until stylus is on LOCATING DOT.
Reclamp work piece.
18. Pick up handle bar and place stylus
guide on line of stencil. Switch router
on and proceed. (Repeat until sign is
completed.)
When going from capital to small
letter, space to desired distance.
MAKING SIGNS USING
SMALL LETTERS
"Modern Writing Style"
19. Pick out letters you are going to use
and find those which come nearest
top and bottom of stencil. Use these
to locate word in CENTER OF WORK
PIECE.
Place router bit cutter on center of
work piece. Locate center of highest
and lowest letter under stencil cover
with stylus on center distance.
Relocate stencil cover if necessary.
Rout highest and lowest letters on
scrap lumber to make sure your work
will be in center of work board.
20. Remove highest and lowest letter and
locate first stencil against inside fold
of stencil cover and up against tack.
Rout first letter. Switch router off.
(Leave bit cutter in groove.)
f F,
SPACING DOT
PUSH
LET ROUTER AND
PANTOGRAPH
RIDE ON WORK PIECE
DO NOT TOUCH
PANTOGRAPH WHEN
MOVING WORK PIECE
LOCATING DOT
HIGHEST LETrER
WORK PIECE
LOWEST LETTER
PUSH WORK PIECE (WITH BIT CU'i-rER IN
GROOVE) CARRYING ROUTER
-7-