Owner`s manual
6. Screw a 3/8-16 HEX NUT on both
of the REAR SUPPORT SCREWS.
Assemble both screws through the
REAR PIVOT BOLTS until the ball
end protrudes 1/2", Snap SLIDE
BUTTON on ball of screw which is on
guide arm side, (FIG. 4) Snap HOLD
DOWN SOCKET on ball of screw
which is on left side. (FIG. 5)
7. This ROUTER PANTOGRAPH can
be used for engraving designs,
animals, signs and other flat work,
also three dimensional wood
sculpturing. These can be done on a
workbench or table. We recommend
a plywood fixture for using with work
holding WEDGES supplied. This
fixture will save time, especially when
making signs, and is a handy way to
store the unit on the workshop wall,
set up and ready to use. See drawing
to right.
OPERATING
INSTRUCTIONS
8.
Take one of the line drawing
template sheets supplied in the
stencil set and engrave in redwood
as your first project. This is the best
way to learn about the unit and get a
feel for its use. We recommend the V-
groove bit for line drawings. Install
the bit in the router collet leaving it
above the router base. Adjust depth
when ready to cut.
9. Place router in the center of adapter
plate, with cord to the rear. Secure
router in place using CARRIAGE
BOLTS, ROUTER CLAMPS,
WASHERS, and WING NUTS. (FIG.
6) Place ROUTER CORD in CORD
HOLDER allowing some slack. (FIG. 5)
10. Lay WORK PIECE on work surface.
(Fixture described in step 7 or
workbench). Place adapter plate on
work piece, with router bit on center
of location to be engraved. Adjust
hold down socket down to work
surface by turning support screw.
When left side tube is parallel to work
surface, lock support screw with nut.
REAR SUPPORT SCREWS
OT BOLTS
FIG. 4
SLIDE BUTTON
318-16 HEX NUT
HOLD DOWN SOCKET
WITH CORD HOLDER
FIG, 5
1/2" PLYWOOD
WIDTH OF WORK PIECE
PLUS 2 3/8" FOR WEDGES
FENCE
3/4" X 3"
/
_ 3/4" X 3"
BACK UF
BLOCK
V-GROOVE AND
CHAMFERING Bl=r
48"
ROUTER CLAMP
CARRIAGE BOLT
WING NUT
FIG. 6
BACK UP BLOCK
-5-