Owner`s manual

ASSEMBLY
1,
Locate the REAR TUBE ASSEMBLY
and remove the two PIVOT CAPS
which are not holding a tube. With set
of (3) HOLES up, place the end of the
GUIDE ARM on REAR PIVOT,
making sure LOCATING HOLE in
tube is on PROJECTING PIN of
pivot. Secure tube by replacing pivot
cap and SCREWS. With set of (3)
holes up, place the end of LEFT
SIDE TUBE on the other PIVOT and
secure as you did GUIDE ARM. (FIG. 1)
2. Turn the assembly over, Rotate
ADAPTER PIVOTS so half circle
seats are in position to accept tubes.
ADAPTER PIVOTS are fastened to
ROUTER ADAPTER PLATE,
3.
NOTE: Both projecting pins must be
toward rear tube assembly.
Place GUIDE ARM in right side
adapter pivot with projecting pin in
center hole. Secure in place with
PIVOT CAP, SCREWS and NUTS.
Slide nuts in slots of adapter pivot,
see drawing Figure 2B. Place left side
tube in left side adapter pivot with
projecting pin in center hole. Secure
as you did guide arm, (FIG. 2)
Press TUBE CAP in end of left side
tube. (FIG.2)
4. Assemble THUMB NUT three
quarters of the way on STYLUS.
Stylus has a nylon tip. Hold hex nut
(3/8-16) up under STYLUS
BRACKET and assemble stylus
through stylus bracket and thread
through hex nut. Secure with thumb
nut. (FIG. 3)
5. Screw the two HANDLE KNOBS on
HANDLES.
REAR PIVOT REAR TUBE ASSEMBLY
PROJECT,.GP'N/ i
LOCATING HOLE _ _ ',
/
OU,DEA.MSCREWS/\
X / LEFT SIDE TUBE
(3) HOLES
FIG. 1 / _,\
PROJECTING PiN :: _'
_ _SLIDE NUTS IN SLOTS
_' -t FIG. 2B
t' P,VOTCAPS
)
TUBECAP '
ADAPTOR PIVOTS, / '
NUTS
ROUTER ADAPTER PLATE !_
FIG, 2 //
STYLUS BRACKET
STYLUS HANDLE
ANDLE KNOB
3_ _ ___/.-_ HEX NUT
FIG.
NYLON TIP
-4-