Owner`s manual

EASY DOES IT
30. After reading helpful hints you are
ready to rout a 3D sculpture. A
6" x 6" pattern will take a couple of
hours to complete. The stylus will
have to touch every place on the
pattern. Move the stylus with an even
feed and along grain lines of the
pattern.
HELPFUL HINTS
• Rest your forearm on bench for better
control,
3D
ENGRAVINGS
Start routing at the highest point-and
work your way down to the lower
places, Avoid leaving tall thin sections
because they will chip away easily.
Avoid letting the stylus fall off ledges
but let the stylus down gently under
control over irregular surfaces.
Suggested way to finish a 3D
engraving is to lightly burn the
surface with a torch to bring out
detail and then stain or varrjish.
Easy way to finish a sign or line '
engraving. Paint entire board with
quick drying black enamel. (Aerosol
can is handy.) Plane off surface of
sign, using small plane or rasplane
(not sandpaper). This leaves paint in
each letter.
° Children's color books have a wide
selection of lille drawings of all types
for imagination.
ALSO AVAILABLE AT SEARS
CAT. NO. -925172
ELECTRIC FOOT PEDAL SWITCH
USE WITH 115V A.C.
POWER TOOLS WHICH
DRAW 15 AMPS OR LESS
A CONVENIENT ON-OFF
CONTROL FOR THE
SCROLL SAW
GIVES HANDS FREE
OPERATION OF THE
ROUTER WHEN USED
WITH PANTOGRAPHS
-10-