Operator`s manual

REPLACEMENT OF CARBON BRUSHES (Ffg_ 27)

Replacement brush sets are available throughSears Partsand Repair Centers

1 Unplug the _routermotor before inspecting or replacing brushes

2 Replace both carbon brushes when either has tess than1/4-In length of carbon

remaining, or if the spring or wire Is damaged or burned

3 Using a stetted screwdriver, remove thebtack plasticcap on each side of the router

motor (Fig 27) and carefullywithdraw Ihesprlng-foaded brush assemblies Keep

brushes clean and sliding freely in their guide channels,

I NOTE:To reinstall the same brushes, make sure the brushes go back in the |

same way they came ouLThls will avoid a break-In perlod_

]

4 tnsert new bnJsh assembliesInto guide channels,withthe carbonpart going in first,

being cerfaln to fit the two motet "ears_ Info lhelr slots in the channel (Fig 27)

5 Rememberto replace both end caps after [nepecf)ngor servicingbrushes, Tighten the

caps snugly,but do not over-tighten The routershou/d be allowedto "RUN IN" (run at

no load withouta cutterbit) for 5 minutes before use, toseat the new brushes properly

Fig,,27

Z_ WARNING: For your safety, ALWAYS turn off switch end unplug routermotor from the power source before performing any maintenance or cleaning°

LUBRICATION

All of the bearings in thistoolare lubricatedwitha su|flcientamountof hlgh-g_ade

lubi'lcant for the llfe of |he tool under normal operattng cendtttons Therefore, no further

lubrication is required

17543