Operator`s manual

INTERNAL ROUTING WITH FIXED BASE (Figs, 17, 17a, 17b and !8)

1 WIIh doplh-of-culseL tilt fixed base router and p_aceon workptecewiIh leading

edge of sub-bass conlacIIng workpIece lirst (Fig17)

2 Turn motor "On" and lel motor build up to Its fult speed, be carefulnot to let cutter bii

contactthe workptece

3 To begin your cut, gradually feed the cutlerbit Into the

workplace unlit the subbase Is level with the workplece (see Fig 17a and 17b)

4 When cul ts compleled, turn motor "Off" and let cuiterblt come to a complele slop

before removing ti from lhe workplece,

5 Unplug rouler from power source, placerouter upside down on workiabIe, Inspecl

Iinlshed cul tn workplece

Fig. 17

Flg_17a

Fig, 18 Feed Direction _-- ,/

Edge

Guide

lnlernat siotiing

on workptece wllh fixed base

Feed Direction -->.,

f_ WARNING: Always securely clamp your workplece and keep a firm grip

on the router base with BOTH HANDS at all times, Failure to do so could result In

loss of control causing possible serious personal Injury,

f_ WARNING: Removing cutter bit from workpteee while tt is still rotating

could damage workplece and result In loss of control, causing serious personal

Inluryo

NOTE: Making test cuts Is essential with most routing applications, Even with

cereful set-ups you won't know exactly how the cut wtll go until you try It out,

A lest cut will give you a feel for the set-up, the router's speed, the depth of

cut and how the cutter bit reacts to the workpleoe,

17543